Call 412.415.0575

MON - FRI 9AM - 5PM EST

Free Shipping on U.S. Orders Over $79! Deal of the Day New Arrivals Clearance

  Home > Gun Parts > Cyclone Feed Upgrades >

  TechT Vortex SS Cyclone Feed Mod
TechT Vortex SS Cyclone Feed  Mod


 
Our Price: $34.99

Stock Status: In Stock

Availability: Usually Ships in 24 Hours
Product Code: TECH-VORTEX-SS
Qty:

Description Extended Information
 
The Vortex Mod was the FIRST hard-coated and teflon impregnated aluminum internals to replace the stock plastic internals of the Tippmann Cyclone Feed to be released in the paintball industry.

The Vortex Mod SS now incorporates a stainless steel axle and design changes to make it the most durable and easiest upgrade to install.

The popularity of electronic controls in Tippmann A5, X7, and 98's that allow for rates of fire of up to 30 BPS, has warranted the need for higher performing internals for the cyclone feed that will allow the loader to keep up with the marker.

TechT's testing has shown that the Vortex Mod SS will allow the Cyclone feed to work at lower pressures, feed faster, and virtually never wear out. If it does we will replace the worn parts for life.

While stock cyclone internals need to be replaced on a regular basis, the Vortex Mod is a permanent solution that makes the cyclone faster and more reliable.Since its release, the Vortex Mod has been the most widely used, and most trusted name in cyclone upgrades. The Vortex Mod SS is specifically designed to be the fastest, smoothest actuating, and most durable/long lasting upgrade available. And did we mention it was easy to install?

The "Genuine" Vortex Mod was by far the most durable and highest performing cyclone upgrade available. In the past we said that if our Vortex Mod wasn't the best Cyclone Ratchet Upgrade in the world that we would redesign it to crush the competition, and that's exactly what we did.

With a new stainless steel axle and design refinements it is now far and away the "best of the best".

The Vortex Mod SS will feed upwards to 30+ balls per second and continue to load down to pressures as low as 150 psi.

Stock parts only feed up to 15 balls per second and only down to a pressure of 400 psi.

Customer ReviewsShare your knowledge of this product with other customers... Be the first to write a review

(Your shopping cart is empty)