Gun Parts

Replacement factory replacement charging handle BRH (Complete) for the Valken (Milsig) M17 Paintball Marker.Features:Complete M17 BRH (Bolt Reset Handle) Assembly KitBolt reset handle is used only in case that bolt got stuck in front positionInstallation...

This part allow your to run air through the rear of your FIRST STRIKE (Tiberius Arms) T8.1, FSC and XP Pistols. Works on T8.1 pistols with a serial number 2000 and up and all FSCs.

2 Pack of additional guide bars that are made specifically for the First Strike Float Stock.

Factory Spare Magazine for the T4E TMP1 .43 cal paintball pistol.  Includes a spare spring for rubber ball use.  Holds (8) rounds and (1) 12 gram cartridge. 

Tippmann TCR Factory replacement part: TA21110 (76535).  TA21110 is also known as the 'TiPX HPA Valve Kit'.

Premium oil from Valken for all paintball, airsoft and air guns.Features:Works with all paintball, airsoft and air gunsCompatible with virtually all O-rings, gaskets, valves and non-silicone sealsExcellent for plastic, metal and rubberWorks in wide...

UPDATED VERSION: Crimped, Threaded, and LoctitedFactory 16 Joule Valve System for the HDR68 Revolver from T4E (Umarex).   NOTE: 16 Joule units are for target practice only, they should NOT be used for Paintball play or any other purpose. ...

DYE DAM RF Board.  Compatible with the DYE Box Rotor.   Replacement Part: R30710069

Factory Spare Magazine for the T4E TPM1 .43 cal paintball pistol.  This model includes the new Quick Piercing Feature.  Simply add the 12 gram cartridge and secure with the lower thumb wheel.  Insert the magazine into the pistol and bump...

5 Pack of Valken M17 Magazine Top Springs.  This spring attaches to the detent bar at the top of the magazine feed adapter.  Part # 111628.

FIRST STRIKE FSC Compact Seal Factory replacement part: N10-0040

Need more shot capacity for your Umarex TR50, HDS or other T4E variant that uses the 12 gram CO2 threaded quick puncture assembly?  The MCS remote air adapter allows you to use a standard remote line or standard paintball tank to air-up your marker...

Replacement Bolt Stem for the Valken M17 Marker. (103562)

This factory kit allows you to attach a hopper or electronic loader to the top of your Valken M17.  Includes hopper feed adapter and mock magazine.Fits the M17 only - will not work with CQMF.

Valken M17 Regulator Cap Replacement. Part 111635.

Finally an easier solution to air-up your launcher. This adapter screws in place of the factory 90 degree macroline fitting on the side of the Havoc Launcher and allows you to screw-in a standard pin valve tank or remote line. Use a small CO2 or nitrogen...